No Result
View All Result
Quesions Library
Contribute
No Result
View All Result
No Result
View All Result

 


Questions › Category: 350-601
Filter:AllUnanswered
Which MAC address is an HSRP version 2?
Admin asked 10 months ago • 
17 views0 answers0 votes
An engineer must configure a Nexus 7000 series switch for HSRP on VLAN 100. When fully functional, the router must be the active master. Which set of commands must be used to implement the scenario?
Admin asked 10 months ago • 
21 views0 answers0 votes
Refer to the exhibit. All switches are configured with the default OSPF priority. Which configuration should be applied to ensure that the SW2 Cisco Nexus switch controls the LSA floods and advertises the network to the remaining nodes in the OSPFv2 area?
Admin asked 10 months ago • 
22 views0 answers0 votes
DRAG DROP – Refer to the exhibit. In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements: ✑ R1 must be the active RP. ✑ R2 must be the backup RP that is used only if R1 is not reachable. Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used. Select…
Admin asked 10 months ago • 
71 views0 answers0 votes
APIC EPG Resolution Immediacy is set to "Immediate". Which statement is true about the Deployment Immediacy for VMM domains associated to EPGs?
Admin asked 10 months ago • 
19 views0 answers0 votes
What is an advantage of streaming telemetry over SNMP?
Admin asked 10 months ago • 
15 views0 answers0 votes
What are two capabilities of the Cisco Network Assurance Engine? (Choose two.)
Admin asked 10 months ago • 
16 views0 answers0 votes
Refer to the exhibit. What is the result of running the command presented?
Admin asked 10 months ago • 
25 views0 answers0 votes
Due to a major version change, an engineer must perform a software upgrade on a Cisco Nexus Series switch. Which two technologies should be implemented to reduce disruptions to the network during the upgrade? (Choose two.)
Admin asked 10 months ago • 
19 views0 answers0 votes
A customer has a requirement to deploy a cloud service and needs to have full control over the underlying OS, data and applications. Which cloud model meets this requirement?
Admin asked 10 months ago • 
23 views0 answers0 votes
Refer to the exhibit. A flapping link issue has been reported on the vPC keepalive link. A packet capture has been activated on the Cisco Nexus switch. What is the destination IP address of the vPC keepalive packets that are sent by the switch?
Admin asked 10 months ago • 
16 views0 answers0 votes
Refer to the exhibit. A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server. Which configuration must be added on the remote OTV AEDs site? A. B. C. D.
Admin asked 10 months ago • 
26 views0 answers0 votes
Which configuration implements static ingress replication? A. B. C. D.
Admin asked 10 months ago • 
25 views0 answers0 votes
Refer to the exhibit. What is configured as a result of running these commands?
Admin asked 10 months ago • 
22 views0 answers0 votes
Host1 is in VLAN100 located in DataCenter1 and Host2 is in VLAN200 located in DataCenter2. Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts? A. B. C. D.
Admin asked 10 months ago • 
13 views0 answers0 votes
The engineer must configure SPAN on a Cisco Nexus 5000 Series Switch to get a capture of the traffic from these applications for an in-depth packet analysis. Which two SPAN characteristics must be considered? (Choose two.)
Admin asked 10 months ago • 
18 views0 answers0 votes
Which adjacency server configuration makes two OTV edge devices located in the same site bring up the dual-site adjacency? A. B. C. D.
Admin asked 10 months ago • 
21 views0 answers0 votes
Refer to the exhibit. The STP priority of N7K-1 and N7K-2 are the lowest in the network. Which statement describes STP on the vPC?
Admin asked 10 months ago • 
19 views0 answers0 votes
A small remote office is set to connect to the regional hub site via NSSA ASBR. Which type of LSA is sent to the remote office OSPF area?
Admin asked 10 months ago • 
20 views0 answers0 votes
Refer to the exhibit. What must be connected to clear the HA NOT READY status?
Admin asked 10 months ago • 
20 views0 answers0 votes
« Previous1…24252627Next »

Other exams

No Result
View All Result

Welcome Back!

Login to your account below

Forgotten Password? Sign Up

Create New Account!

Fill the forms below to register

All fields are required. Log In

Retrieve your password

Please enter your username or email address to reset your password.

Log In